- #Separation studio 4 print to regular printer how to#
- #Separation studio 4 print to regular printer manual#
- #Separation studio 4 print to regular printer full#
- #Separation studio 4 print to regular printer software#
This often results in uneven distribution of layer separation forces. Moai also uses side-tilting mechanism to peel off cured layers. So sometimes intricate prints might come out better on PDMS VAT. Usually cured layers tend to stick less to PDMS than to FEP. All models were oriented along the line of VAT tilting mechanism.īefore diving into results, let’s briefly discuss main differences between Peopoly Moai and Anycubic Photon resin 3D printers.Laser power was set to recommended value for black Peopoly Model resin.Latest firmware with all default settings.We conducted this part of the experiment with Peopoly Moai 3D printer using black Peopoly Model UV resin with following settings. Surface lines on medium-sized tips with highest density also were minor and results were acceptable. However, it performed a bit worse than large-tipped version with highest density as wheels came out more deformed. This time, version with highest density also showed best performance. Each model had a different support density. Models with medium tips also 3D printed successfully. Remaining models with medium and large tips at highest density with additionally added supports 3D printed successfully. Version with small tips and high density failed completely. Results with this model are very similar to half-sphere. 3D printed models show that with thicker-tips additional supports were unnecessary at all. Here you can see all auto supported models together with models with manually added additional supports. We generated both at the highest density. On the other hand, we had a bit different story with medium-tipped and large-tipped supports. Furthermore, even a bunch of intentionally added additional supports did not help to get decent result. Layer separation forces were too high for tips of this size even with such favorable shape as sphere. Both models failed and we printed “supports only”. Then we supplemented auto generated supports with a bunch of additionally manually added supports (model on the right).
For this attempt, we placed small-tipped supports at the highest density (model on the left). Half-sphere modelĪs expected, all resin supports with small tips failed miserably. This part was conducted with Anycubic Photon 3D printer using our AMD-3 LED UV resin with following settings.īelow, we present you our “Anycubic Photon” results and some comments about each of them.
#Separation studio 4 print to regular printer manual#
#Separation studio 4 print to regular printer software#
We used XYZware software to place supports and relied on automatic support generation function. We made some conclusions at the end of this article. This time we have chosen two different machines: Peopoly Moai resin 3D printer and Anycubic Photon resin 3D printer. In order to evaluate our assumptions and see how various settings impact the final result, let’s conduct a simple experiment. Testing settings for failing resin supports
#Separation studio 4 print to regular printer full#
We recommend reading the full article here: 6 Key Principles of 3D Printing Supports that Work. In a previous article we listed 6 principles that you have to consider to make sure, that your prints wouldn’t fail while resin 3D printing supports. This time we set out to prove our assumptions with an experiment.
#Separation studio 4 print to regular printer how to#
In a previous blog post “6 Key Principles of 3D Printing Supports that Work” we have covered why support structures are needed, how to properly set them up for resin 3D printing and the key reasons behind failing of supports. That is when you get only support structures on the build plate after 3D printing instead of the intended object. We have noticed one standard issue for most beginners of “bottom-up” style SLA 3D printing.